HazardKey Quick Disconnect License Plate Mount

Your plate is the first thing to catch a rock, drag on an approach, or get folded over on a hard line. This mount lets you pull it before the trail and put it back before the pavement, in seconds, without tools and without leaving hardware behind in the dirt.

Two quick disconnect receiver hooks bolt into the HazardKey slots on your fairlead and stay there. The plate carrier locks into those hooks on a pivot pin on one side and a detent pin on the other. Slide the pivot in, drop the detent pin, and you're secure. Pull the detent and the plate lifts right off. Because the hooks mount to the key slots, you can set them where they give you the best plate alignment on your bumper and the clearance you need around your winch line and recovery points.

• Pull it before the trail: get your plate out of harm's way before the rocks find it
• Pivot and detent design: slides into place on the pivot pin, locks with the detent pin, no tools at any point
• Multiple mounting positions: set the receiver hooks along the key slots to dial in alignment and clearance
• Built for the HazardKey Hawse Fairlead: receiver hooks included, no additional brackets needed

Built to Last

• CNC machined from 6061 billet aluminum. No castings, no stamped sheet metal, just solid pieces engineered for strength
• Hard coat anodized finish for serious corrosion and abrasion resistance, whether you're on the trail, at the coast, or parked outside year-round
• Stainless steel hardware included throughout, including the plate mounting hardware, so you never deal with rust streaks bleeding down your paint

Designed and Made in the USA

Every mount is designed and manufactured in the USA, from raw billet to finished, anodized part. That means tighter quality control, and designs that started as parts we wanted on our own Jeeps, not products a committee approved.

Installation

Bolt the two included quick disconnect receiver hooks into the HazardKey slots on your fairlead, positioned for the plate alignment and clearance you want. Set them into the slots at the orientation you need and tighten down. Mount your plate to the carrier with the included stainless hardware. Basic hand tools are all you need, and this is the only part of the setup you do with tools.

From there it's tool free. To install, slide the carrier onto the pivot side and drop the detent pin. To remove, pull the detent pin and lift the carrier off. Seconds either way.

Compatibility

• Requires a HazardKey Hawse Fairlead, sold separately
• Fits standard US license plates

What's Included

• 1x Quick Disconnect License Plate Mount
• 2x Quick disconnect receiver hooks
• Complete stainless mounting hardware, including plate mounting hardware

Patent Pending